Arcbro Stinger 4800 CNC Cutting Table 1300x2500mm

You can cut mild steel, stainless and even aluminium.  

On mild steel you can easy cut 20mm clean with good accuracy .

This table is rated for 16mm mild steel plate but should you wish to buy the next model up a 30mm table is available. 

There are many variables including amps, plate thickness, machine speed which all impact on durability. The good news is these are relatively low cost and quick to change should wear happen.  

There is a very fine gap between the plasma tip and electrode. Even small amounts of moisture or compressor oil can decrease the life of your parts. We have included an air filter but upgrading to a high-quality air dryer is a good option.  

The table itself is single phase and doesn’t have a high current draw but the plasma will need three phase power. Should you only have single phase and want to look at other options or combinations give us a call .

Table - Proline have been working with ArcBro for many years and have regular stock coming from their factory. This means that should the worst happen and a component fail often we have parts on site or can get them on the way fast (One year warranty on the table).
Plasma – The Strata AdvanceCut125 has been the pride of our fleet with next to no issues in a demanding industrial environment. We have full spare parts in New Zealand and can sort any issues fast (3 year warranty on the power source)  

Proline assemble and test the table prior to it leaving site so the site set up at your end is minimal. 

Yes, there is some learning to do but we have tried to minimise this by offering a range of videos to get you started which can be found on You Tube – Proline Industrial. The machine comes with some basic software for cutting and nesting but often people choose to run their own programs such as Draft Site. The practical side of cutting is taught on site at Proline.  

Yes, you can. Though it is a good idea to check your consumables prior to cutting at times these will need preplacing mid process. You can stop the machine, change the parts and re start from the same point. 

The ArcBro has a demo mode function that can be used to check every thing is heading in the right direction before you launch into the job. This is great for piece of mind as we can all make mistakes.