Harris Blockade 2.0mm Phosphorus-Tin-Silicon Alloy Brazing Rods

I'm in my early 70's a tinkerer, first time at this stuff brazing brass rods for a sculpture.
Mark has been a wealth of knowledge and suggestions of what i needed and guidance.
I'm brazing 4mm brass rod both together and to stainless ferrules.

He suggested the silver45% for the brass to stainless and Harris 2% for the brass to brass for cost effectiveness, the smaller diameter Harris rod made less conspicuous joint when compared the Repco 2% i had been experimenting with as was all I had at the time. Before Id spoken with Mark.
I'm very happy with the results as I've several 100 joints to make.

Tks very much , has made my project so much easier

Regards
Mike